Attention, during firmware update do not disconnect power supply. Firmware update is possible though web interface (after typing IP address of the device into web browser).
Process for firmware update, version v1.1.6 or later:
open web site for R060, go to Administration and upload new firmware file (ID_23.bin).
Version notes:
Version 1.2.4
- default net configuration saving into flash repaired
- new logo on the web
Version 1.2.3
- added default of EEPROM register, in modbus and on the web
- SW reset added in modbus
- transition from LwIP to FNET
- source pool update
Version 1.2.2
- setting slave address for modbus RTU in init mode at 1 (not seen in registers)
Version 1.2.1
- „jumpout“ from addressing mode repaired
- generic / datapool command put in operation in simple mode
- search for active demands restricted to answering complex/simple mode
Version 1.2.0
- saving of application data into NVRAM put in operation
- update to actual source pool version
- logger put in operation (disabled in the release)
- EEPROM statistics put in operation (low level writes, read fails, write fails), they are saved into NVRAM
- backup file with configuration moved to the system FS
- deleted error from v118, that device in idle state autoaddress continued in communication and peripherals did not answered on-demand command
- added registers with timing setup, for the case that some peripheral do not cope with the norm.
- setup for debug pins
Version 1.1.9
- modification of SN parsing – looser, delimiter is any nonnumeric sign, if user demands starting zeros, it is not necessary to use delimiter and vice versa
- during start of addressing event from the web interface (Wink, Get SN, Set addr, Bus scan, Auto addr) first it will wait for end of communication of previous event (during running bus scan only one address, i.e. 3 timeouts )
Version 1.1.8
- temporary hotfix
- repair of parsing SN from web for PP address
- start of autoaddressing is prohibited, until addressing is idle (during bus scan, if clicking on auto address the duplicate address 1 was set)
- if device does not pass though bus scan, then during de-addressing by manual input of SN, addressing will go back to „resting state“ (no way how to check)
Version 1.1.7
- source pool update
- into script for creating fw for the web update option for size change of executable part of binary was added